Blog 

INGCO turns up in every tool search in Singapore, usually at a price that makes you suspicious. A 12-piece ratchet spanner set for around $70 when the German equivalent is three times that. A 10" table saw for about the price of one premium cordless drill. Gloves for roughly the cost of a coffee.

So the question everyone actually asks is: is it any good, and where do I buy it without ordering blind off a marketplace listing? Here is a straight answer from a shop that stocks over 1,300 INGCO lines.

What INGCO Actually Is

INGCO is a value brand with enormous range. That is the whole proposition. It covers much the same ground as the premium names — hand tools, cordless and corded power tools, accessories, pumps, measuring gear, storage, consumables — at a fraction of the price, because it is built to a price.

It is not pretending to be Makita. If you are on a tool eight hours a day, every day, buy the Japanese or German one; it will outlast three of these and cost you less per year. We sell those too and we will tell you so in the shop.

But most tools in most hands are not used eight hours a day. That is where INGCO earns its place.

What INGCO Is Genuinely Good At

• Hand tools and sets. This is the strongest part of the range. A 22-piece 3/8" socket set with a 72-tooth ratchet comes in under $60, and a 6-piece combination spanner set is well under $20. Chrome vanadium, properly finished, and for a toolbox that gets opened twice a week they are fine. Spanners do not have a motor to burn out.
• Consumables and things that go missing. Utility knives under $10 with twenty blades in the pack. Bricklaying trowels for a few dollars. Work gloves for about a dollar fifty a pair. When a tool's realistic lifespan is "until someone walks off with it", paying premium money is just donating to whoever took it.
• Measuring gear. A 55m laser distance meter sits around $40; the 70m version with a tape measure in the box is still under $80. These are solid-state devices doing one simple job, and the gap between cheap and expensive is far narrower than it is for anything with bearings.
• Storage. A 16" stackable tool box is under $20, and a four-piece tool bag combo lands around the $100 mark. Plastic boxes are plastic boxes.
• Second tools and backups. The one that lives in the van, the spare on the third floor, the one you lend out.

Where To Be Careful

• Anything you will run daily under load. Cordless drills and grinders in production use are where the price difference shows. The motor, the bearings and the battery chemistry are what you are not paying for.
• Batteries. A 12V pack costs roughly a third of what the premium brands charge — but you are also buying into a platform with a smaller accessory range and shorter cell life. Think about where that leaves you in three years.
• Tools where failure is expensive or dangerous. If it is holding a load, cutting at speed next to your hand, or the job stops when it stops, buy the better one.

The Parts of the Range Most People Miss

Ask anyone what INGCO sells and they will say hand tools. The catalogue is far wider than that:

• Water pumps — gasoline, centrifugal and submersible sewage. A 3" gasoline pump with 32m head comes in under $500, and a 1.5HP submersible sewage pump with float is a little over $300. Useful for sites, basements and landscaping, and a category most people do not think to check here.
• Wet and dry vacuums — up to a 2400W twin-motor 75-litre unit, plus 12V and 20V cordless versions starting well under $100.
• Air tools — 150mm air sanders and 1/2" air ratchet wrenches, both around the $100 mark or below.
• Masonry and plastering — trowels, rubber floats, skimming blades and caulking guns. Renovation crews go through these, and the price difference across a job is real.
• Electrical test gear — circuit testers, voltage-detecting wire strippers and digital manometers.

Who Should Buy INGCO

Contractors kitting out a crew, where buying premium for every hand is not realistic. Facility and maintenance teams keeping spares on each floor. Renovation crews buying consumables by the box. Workshops needing a backup. And home owners fitting out a new flat who need forty things at once and will use most of them a handful of times a year — if that is you, start with our first toolkit guide for a new BTO or resale flat.

If you are choosing between brands for something you will genuinely use hard, read Makita vs DeWalt vs Bosch first, or the cordless drill buying guide.

Where To Buy INGCO in Singapore

The advantage of buying tools in person is that you get to pick them up first. With a value brand that matters more, not less — the difference between a set that feels right and one that does not is obvious in your hand and invisible in a product photo.

Both A.C.T. Hardware showrooms carry INGCO, and you are welcome to open the boxes:

Geylang showroom
645 Geylang Road, Singapore 389575
+65 6546 7446

Nordcom Two
2 Gambas Crescent #03-19, Nordcom Two, Singapore 757044
+65 6255 3446

Opening hours are Monday to Friday, 8.00am to 5.30pm. Trade accounts and bulk pricing are available — if you are kitting out a crew or buying consumables by the carton, talk to us rather than adding to cart.

Browse the full INGCO range → for current prices.

Not sure which one suits your job? WhatsApp us at +65 8978 9808.